Additional Information How to Connect a Printer
76 Agilent 8163A/B, 8164A/B, and 8166A/B User’s Guide, Fourth Edition
How to Connect a Printer
You can use a printer connected to the parallel port on the rear panel
of your mainframe, see “Input and Output Connectors” on page 289
for a diagram of your mainframe’s rear panel.
You can use either of the following printer types:
•<HP PCL>, a printer that uses the Hewlett-Packard Printer Control
Language, or
•<EPSON 8 pin>, a printer that is compliant with Epson 8 pin
printers.
To set up the printer, perform the following steps:
1 Set up your printer as described in your printer’s User’s Guide.
2 Connect a parallel cable between your printer’s parallel connector
to the parallel port on the rear panel of your mainframe, see “Input
and Output Connectors” on page 289 for a diagram of your
mainframe’s rear panel.
3 To select a printer type, see “How to Select the Printer Type” on
page 70.
You can then print out any of the following information:
• a help screen, see “How to Get Help” on page 50,
• data from an application, see “Printing Application Measurement
Results” on page 265.
To Next Page
Loading...
Need help?
General
