Installation and Maintenance AC Line Power Supply Requirements
276 Agilent 8163A/B, 8164A/B, and 8166A/B User’s Guide, Fourth Edition
If you need to turn off the power, unplug the instrument at the mains
or remove the power cable connector from the appliance coupler at
the rear of the instrument. For this reason, the power cable connection
should be easily accessible - allowing you to turn off the power quickly.
If the instrument is in a cabinet, it must be disconnected from the line
power by the system’s line power switch.
The type of power cable shipped with each instrument depends on the
country of destination.
NOTE You only need to use the line power cable to connect to the AC
adapter.
WARNING To avoid the possibility of injury or death, you must observe the
following precautions before switching on the instrument.
• Insert the power cable plug only into a socket outlet provided with a
protective earth contact. Do not negate this protective action by the
using an extension cord without a protective conductor.
• Do not interrupt the protective earth connection intentionally.
The AC power requirements are summarized on the rear panel of the
instrument.
Figure 179 AC Power Requirement Markings - Agilent 8163A/B
Figure 180 AC Power Requirement Markings - Agilent 8164A/B
To Next Page
Loading...
Need help?
General
