Agilent Technologies InfiniiVision 5000 Series User Manual

Web Interface 9
InfiniiVision Oscilloscopes User’s Guide 279
After the LAN connection is configured, you can find the oscilloscope’s IP address and
use it to access the instrument’s Web interface:
• On an oscilloscope that has a display, you can find the IP address assigned to the
oscilloscope in the [Utility]&I/O screen.
• On a 6000L Series oscilloscope without a display, you can use the Agilent Connection
Expert to find the oscilloscope’s IP address.
To find a 6000L Series oscilloscope’s IP address using Agilent Connection
Expert
The Agilent Connection Expert is part of the Agilent IO Libraries Suite software that
comes on the Automation Ready CD-ROM provided with the oscilloscope.
1 Install the Agilent I/O Libraries Suite from the CD that was supplied with the
oscilloscope. If you do not have the CD, you can download the I/O Libraries Suite from
www.agilent.com/find/iolib.
2 Start the Agilent Connection Expert application from the Agilent I/O Libraries Suite
program group.
3 When the Agilent Connection Expert application is displayed, select Refresh All.
4 Right-click LAN and select Add Instrument.
5 In the Add Instrument window, the LAN line should be highlighted; select OK.
6 In the LAN Instrument window, select Find Instruments....
7 In the Search for instruments on the LAN window, LAN and Look up hostnames
should be checked.
8 Select the Find Now key. (NOTE: It may take up to three minutes before the
instrument is found. If the instrument is not found the first time, wait about one
minute and try again.)
9 When the instrument is found, select OK and OK to close the Add Instrument
windows.
Now, you can see the oscilloscope’s IP address in the Agilent Connection Expert and use
it to access the instrument’s Web interface.

Agilent Technologies InfiniiVision 5000 Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 5000 Series
Category	Test Equipment
Language	English