Utilities 14
InfiniiVision Oscilloscopes User’s Guide 395
For a 2-channel oscilloscope, connect a BNC tee to the equal length cables. Then connect
a BNC(f)-to-BNC(f) (also called a barrel connector) to the tee as shown below.
U
SER CALIBRATION CABLE FOR 2-CHANNEL OSCILLOSCOPE
For a 4-channel oscilloscope, connect BNC tees to the equal-length cables as shown
below. Then connect a BNC(f)-to-BNC(f) (barrel connector) to the tee as shown below.
U
SER CALIBRATION CABLE FOR 4-CHANNEL OSCILLOSCOPE
Longer cable
to TRIG OUT
To Channel 1
To Channel 2
Longer cable
to TRIG OUT
To Channel 3
To Channel 1
To Channel 4
To Channel 2
To Next Page
Loading...
