Alcatel-Lucent 7750 SR - Page 318

VLL Services Command Reference
Page 318 7750 SR OS Services Guide
— secondary-shaper secondary-shaper-name
— no secondary-shaper
— [no] qinq-mark-top-only
— qos policy-id
—no qos
— [no] queue-override
— [no] queue queue-id
— adaptation-rule [pir adaptation-rule] [cir
adaptation-rule]
— no adaptation-rule
— avg-frame-overhead percent
— no avg-frame-overhead
— cbs size-in-kbytes
— no cbs
— high-prio-only percent
— no high-prio-only
— mbs {size-in-kbytes | default}
— no mbs
— rate pir-rate [cir cir-rate]
— no rate
— [no] scheduler-override
—
[no] scheduler scheduler-name
— rate pir-rate [cir cir-rate]
— no rate
— scheduler-policy scheduler-policy-name
—no scheduler-policy
— eth-cfm
— mep mep-id domain md-index association ma-index [direction
{up | down}]
—no mep mep-id domain md-index association ma-index
— fault-propagation-enable {use-if-tlv | suspend-
ccm}
—no fault-propagation-enable
— eth-tunnel
— path path-index tag qtag[.qtag]
—no path path-index
— ingress
— filter [ip ip-filter-id]
—no filter
— [no] hsmda-queue-override
— packet-byte-offset {
add add-bytes | subtract sub-
bytes}
—no packet-byte-offset
— queue queue-id [create]
—no queue queue-id
— rate pir-rate [cir cir-rate]
— no rate
— slope-policy hsmda-slope-policy-name
— no slope-policy
— secondary-shaper secondary-shaper-name
— no secondary-shaper
— match-qinq-dot1p {top | bottom}
— no match-qinq-dot1p
— qos policy-id [shared-queuing]
—no qos