Alcatel-Lucent 9500 - Figure 3.62 - 1+0 Repeater Configuration; XPIC (with MPT-HC;HC-HQAM;XP;XP-HQAM Only, for MPR-E)

Functional description
MPR-e and MSS-1c User Manual 3DB19901EFAA Edition 01 151
Figure 3.62 — 1+0 Repeater configuration
This solution is available with MPT-HC/HC-HQAM/XP/XP-HQAM/9558HC with the
following conditions:
• Repeater(s) inserted between two terminal MSS-4/8
• DATA exchange between the two MPR-e through an optical link only
• Synchronization configured in SyncE
• No XPIC configuration
• QoS policy aligned on the 4 stations
• Service: TDM2ETH, Ethernet traffic
3.10.8.7 — XPIC (with MPT-HC/HC-HQAM/XP/XP-HQAM only, for MPR-e)
The MPT-HC/HC-HQAM/XP/XP-HQAM supports Co-channel Dual Polarized (CCDP)
operation using a built-in Cross-polarized Interference Cancellation (XPIC) function. This
function is implemented as follows:
• for MPT-HC/XP transceivers, by installing the RPS+XPIC external module
• for MPT-HC-HQAM/XP-HQAM transceivers, which include integrated XPIC and
RPS functions, no hardware modules are required. An RTU software upgrade is
required to enable XPIC functions
MSS-4/8
23093
MSS-4/8
MPT Power Unit /
MPT Extended Power Unit /
Battery
Data
DC DC
MPR-e MPR-e