Alcatel-Lucent 9500 - Default Parameter; LLDP on MPR-E; Transmitting Nearest Bridge Lldpdus

Automatic link discovery
MPR-e and MSS-1c User Manual 3DB19901EFAA Edition 01 183
1. The MPT and the LLDP enabled device advertise their chassis/port IDs and system
descriptions along with other information to each other.
2. The devices store the information they learn about each other in local MIB/databases
accessible via SNMP.
3. Network management systems discover the network topology by crawling the NEs
and querying the MIB on each device.
3.11.2 — LLDP on MPR-e
By default the LLDP functionality is disabled on the Ethernet user interface. The activation
and deactivation of the feature can be done using SNMP or the MCT.
3.11.3 — Transmitting nearest bridge LLDPDUs
The MPR-e originates untagged Nearest Bridge LLDPDUs advertising management
information about itself on its LLDP-enabled Ethernet interface.
The MPR-e includes all the optional TLVs in the outgoing Nearest Bridge LLDPDUs:
• portDesc
• sysName
• sysDesc
• sysCap
• Management Address TLV
This is not configurable.
The MPR-e does not originate Nearest non-TPMR and Nearest Customer Bridge
LLDPDUs.
3.11.3.1 — Default parameter
The LLDP timers are configured with the default values below and can't be modified.
The following are the default values:
• lldpV2MessageTxInternal = 30 (msgTxInterval)
• lldpV2MessageTxHoldMultiplier = 30 (msgTxHold)
• lldpV2ReinitDelay = 2 (reinitDelay)