Alcatel-Lucent 9500 - Figure 4.84 - Network Synchronization Clock Provisioning

Navigator area
MPR-e and MSS-1c User Manual 3DB19901EFAA Edition 01 263
4.9.1.4.9.6 — Network synchronization clock provisioning
Figure 4.84 — Network synchronization clock provisioning
To configure the network synchronization:
• Synchronization role, select in the list:
• “Master” - the NE sends the clock through the radio link to another NE
• “Slave” - the NE receives the clock from the radio link or another source
• Restoration criteria, select a criteria in the list. This is used to configure the behavior
of the synchronization system when it has switched to secondary source and when the
primary source becomes available:
• Revertive means the NEC comes back to the primary source
• Not revertive means the NEC stays locked to the secondary source and will
return to the primary source only when the secondary one will fail
• Primary source, select one of the proposed source
• Secondary source, select one of the proposed source
For more details on the Synchronization, see Synchronization for MSS-1c.
Note: Only the ports (ETH and PDH) previously defined are available to support the
synchronization.