Alcatel-Lucent 9500 - Extended Power Unit); Figure 3.28 - MPT-XP;XP-HQAM Connection; MPT-XP;XP-HQAM Connectivity for MPR-E (Co-Channel XPIC Configuration)

9500 family overview
MPR-e and MSS-1c User Manual 3DB19901EFAA Edition 01 89
Figure 3.28 — MPT-XP/XP-HQAM connection (optical cable for traffic and coaxial
cable to MPT Extended Power Unit)
3.1.6.4 — MPT-XP/XP-HQAM connectivity for MPR-e (co-channel XPIC
configuration)
In this configuration, the MPT-XP/XP-HQAM units must be installed on the OMT that is
directly connected to the antenna. The two MPT-XP/XP-HQAM units must be connected
to the Indoor Section as explained in MPT-XP/XP-HQAM connectivity for MPR-e (1+0
configuration).
The two MPT-XP/XP-HQAM units must also be interconnected through two terminated
cables (XPIC and RPS cables) as shown in Figure 3.29.
Note: The extra length of the RPS and XPIC cables must be bound by using tie-wraps,
either on the pole or on the other cables coming from the ODUs.