Alcatel-Lucent 9500 - 4 NE Management by Software Application; Security Session Management; Figure 4.1 - Session Expiration Message

MPR-e and MSS-1c User Manual 3DB19901EFAA Edition 01 187
4 — NE management by software
application
4.1 — Security session management
The MCT will close automatically after 30 minutes of session inactivity.
This is not applicable in the following cases:
• When the 15 minutes or 24 hours Performance Monitoring is activated (Normalized,
Adaptive or QoS Ethernet)
• When the monitoring of the Power measurements or Modem measurements is
activated
• When the an MPR-e is configured in Single NE mode with 7705 SAR
After 25 minutes of idle session, a message dialog will be displayed on the MCT to inform
the user about the expiration of the session.The user has 5 minutes to decide to continue or
to stop his session. Figure 4.1 shows the expiration message.
Figure 4.1 — Session expiration message
Press the “Stay Connected “button to keep the current session active. The idle period is then
restarted.
Press the “Disconnect” button to close the current MCT session.
If no action is done, the MCT will close automatically after the remaining time displayed
on the message dialog. Figure 4.2 shows the shutdown message.