WebEML start
188 MPR-e and MSS-1c User Manual 3DB19901EFAA Edition 01
Figure 4.2 — Connection lost message
4.2 — WebEML start
This chapter explains all the screens of the WebEML (JUSM/CT), which is started by a
double click on the WebEML icon on the PC desktop.
The WebEML must be connected to the CT port of the MSS-1c or to the MPR-e Ethernet
generic device as explained in the Provisioning chapter.
Refer to Software local copy for information on copying the WebEML from the software
package and connecting the PC to the MSS-1c or Ethernet generic device in order to access
the MPT-HC/HC-HQAM/MC/XP/XP-HQAM/9558HC.
1. To start the WebEML, double click on the relevant icon on the PC desktop. See
Figure 4.3.
Figure 4.3 — WebEML desktop icon
2. NEtO and NEtO Server Manager open. See Figure 4.4.
Note: For MPR-e, the PC should be in the same sub-network as the default IP address of
the TMN in-band (first connection); see the Maintenance and trouble-clearing chapter for
configuration information. If TMN in band is different from the Local NE IP, there also
needs to be a route on the PC with the gateway of the TMN in band.
To Next Page
Loading...
