Navigator area
MPR-e and MSS-1c User Manual 3DB19901EFAA Edition 01 275
This menu allows to change the scheduler operation.
The scheduling mode can be DWRR or HQP.
If DWRR has been selected the DWRR weight can be assigned to a specific egress
queue (queue 1 to queue 5).
Click on the Defaults button to restore the default algorithm.
4.9.1.4.11 — TDM cross-connections for MPR-e
This menu allows you to create TDM2ETH cross-connections.
Figure 4.96 — Cross-connection creation
Note: The scheduling mode refers only to queue 1 to 5, because for queue 6 to 8 the
scheduling mode is fixed to HQP.
Note: Queue 5 is the highest-priority queue; queue 1 is the lowest-priority queue (valid
only for HQP).
Note: the HQP mode can be associated with some queues and DWRR mode can be
associated with other queues. DWRR cannot be assigned to higher-priority queues than
those configured for HQP.
To Next Page
Loading...
