Alcatel-Lucent 9500 - Figure 4.102 - Areas; Figure 4.103 - OSPF Areas Management

Navigator area
MPR-e and MSS-1c User Manual 3DB19901EFAA Edition 01 281
• CT Field (MSS-1c only)
This field is a read-only field with the IP parameters of the PC.
• OSPF Management field
This field includes two areas (Areas and Interfaces) to manage OSPF.
Each OSPF interface is attached to an OSPF Area the OSPF Area Id. For example, in
Figure 4.101, TMN RF is in OSPF Area: 0.0.0.0.
• To add an OSPF Area
Figure 4.102 — Areas
1. Configure the Area Identifier and Area Type fields.
2. Click on the Add button. A configuration message will appear.
Figure 4.103 — OSPF Areas Management
3. Click on the OK button.
Warning: For MSS-1c, If the TMN In-band is not enabled in the Provisioning Tool, it is not
possible to enable the TMN In-band using the WebEML.
Caution: For MPR-e, changes to these parameters will cause the connection with the MPT
to be dropped.
Depending on the changes to the parameters and the type of generic device, it may be
necessary to change the parameters of the PC/device.