Safety rules
MPR-e and MSS-1c User Manual 3DB19901EFAA Edition 01 49
The equipment contains Class 1 laser components according to IEC 60825-1 (paragraph 5).
The laser source is placed in the left side of the optional SFP plug-in, which must be
installed in the Core-E unit.
According to IEC 60825-1, the explanatory label is not applied to the equipment due to lack
of space.
2.4.2.7 — Microwave radiations electromagnetic field (EMF) norms:
labeling and safety instructions
Equipment emitting RF power:
The site must be compliant with ICNIRP guidelines or local regulations if more restrictive.
The following rules must be strictly followed by the customer:
• Non authorized persons must not enter the compliance boundaries, if any.
• Compliance RF boundaries, if any, related to EMF exposure, must be marked.
• Workers must be allowed to switch off the power if they must operate inside
compliance boundaries.
• Ensure good cable connection.
• Install the antenna as high as possible from the floor or area with public access (if
possible, the cylinder delimiting the compliance boundaries, if any, or the cylinder
corresponding to the transmission area directly in front of the antenna with the same
diameter as the antenna, should be more than 2 m high).
• Install the antenna as far as possible from other equipment emitting RF power.
Someone standing in front of the 9500 MPR antenna may cause traffic shutdown.
Place the relevant stickers as listed below:
• On the site when applicable (if people can cross the compliance boundaries and/or the
transmission area of the antenna; for example, roof-top installation)
• Warning label "Do not stand on the antenna axis"
• On the mast (front side)
To Next Page
Loading...
