9500 family overview
84 MPR-e and MSS-1c User Manual 3DB19901EFAA Edition 01
Figure 3.23 — 1+1 HSB for MPT-HC (11-38 GHz)
3.1.6 — MPT-XP/XP-HQAM
The extended power (XP) MPT ODUs are available in two model. Both models share the
same characteristics except where indicated below:
• MPT-XP—supports QPSK, and 8, 16, 32, 64, 128,and 265 QAM
• MPT-XP-HQAM— supports the same range as the MPT-XP, but adds support for
512 QAM and 1024 QAM
MPT-XP is a very high power version of the MPT-HC.
The MPT-XP provides an additional 5 to 9 dB of transmit power as compared to equivalent
MPT-HC.
MPT-XP is XPIC-ready, and requires the installation of a dedicated module.
The MPT-XP-HQAM has an integrated, on-board XPIC function which can be enabled by
software upgrade using a dedicated XPIC RTU license. No additional hardware module is
required.
The power MUST be provided from the MPT Extended Power Unit to the MPT-XP/XP-
HQAM Data+-DC connector.
The MPT-XP-HQAM does not require a solar shield.
The MPT-XP/XP-HQAM is frequency dependent.
Note: An MPT-HC/HC-HQAM/9558HC and an MPT-XP/XP-HQAM can form a 1+1
configuration with the use of a specific cord.
To Next Page
Loading...
