Alcatel-Lucent 9500 - Figure 4.78 - Cross Connection TDM2 TDM (T1 Case)

Navigator area
256 MPR-e and MSS-1c User Manual 3DB19901EFAA Edition 01
4.9.1.4.9.3.2 — B) TDM2TDM cross connection (T1 case)
To configure a TDM2TDM cross connection:
• Select the Port configuration: T1
• Choose the T1 port you want to configure (between 1 and 16)
• In the column Enabled: Check the box
• In the column Flow Id: Enter a valid VLAN Id (between 2 and 4080). Note that
VLAN Id is unique.
• In the column Service Profile: Select TDM2TDM in the list (default value)
• In the column Node Timing: Check the box or not. When it is selected, the
regenerated T1 at receiver side are synchronized to the network element clock (NEC).
Note that corresponding incoming TDM flows shall be synchronous to the NEC at
transmit side.
• In the column XCo to port: Select Radio Port (default value).
The cross connection is established between an T1 port and the Radio port.
• In the column Cable Length: Select the appropriate length in the list
Port T1-1 is being configured as shown in Figure 4.78.
Figure 4.78 — Cross connection TDM2TDM (T1 case)