Alcatel-Lucent 9500 - Figure 4.90 - Per Flow Policer

Navigator area
270 MPR-e and MSS-1c User Manual 3DB19901EFAA Edition 01
Default values are proposed. They can be changed by the operator in the authorized range.
Figure 4.90 — Per flow policer
4.9.1.4.10 — Ethernet traffic QoS for MPR-e
This menu allows to:
1. Select the QoS Classification
2. Set the Classification according to the EtherType
3. Set the Scheduling Algorithms
Note: In 802.1Q Bridge mode, VLAN 1 cannot be selected.
For burst size setting over 8000 bytes, the accuracy of the limitation is not guaranteed.
The flows without flow policer rule are not guaranteed (Yellow frames).
Note: For the QoS the first match for the classification is done according to 802.1p/
DiffServ (point Select the QoS Classification). If there is no match, the classification is
done according to the EtherType (point Set the Classification according to the EtherType).
If there is no match, the Ethernet frame is sent to the lower-priority queue.