Navigator area
MPR-e and MSS-1c User Manual 3DB19901EFAA Edition 01 297
Figure 4.128 — MCT connected to main MPT with failed synchronization log
In case of synchronization failure, check the state of the coupling cable. If
everything is clear, repeat the synchronization operation.
4.9.1.5 — Backup / restore
This menu allows the operator to make a backup (save the NE configuration to the PC) and
to make a restore (download a configuration, from a previously done backup, to the NE).
The backup and restore is done through FTP (by default) or SFTP.
Warning: The MPT-HC can be used to replace a MPT HC-HQAM only if the MPT
HC-HQAM is working in MPT-HC Compatibility mode (see section 4.9.1.4.6).
Note: In an MPR-e in Single NE mode with 7705 SAR configuration, MPR-e backup/restore
is done through the 7705 SAR via an FTP session directly on the 7705 SAR compact flash.
The MPR-e configuration is always saved on the 7705 SAR and can be backed up and
restored as a regular 7705 SAR config.cfg file.
To Next Page
Loading...
