Alcatel-Lucent 9500 - Figure 4.104 - Configuration Message; Figure 4.105 - Areas; Figure 4.106 - Configuration Message

Navigator area
282 MPR-e and MSS-1c User Manual 3DB19901EFAA Edition 01
Figure 4.104 — Configuration message
The 9500 MPR OSPF parameters are:
• Hello Interval: 10 seconds
• Router Dead Interval: 40 seconds
• Retransmit Interval: 5 seconds
• Interface Transit Delay: 1 second
• MTU: 1500 bytes
• To remove an OSPF Area
Figure 4.105 — Areas
1. Configure the Area Type, then click on the Remove button. A configuration
message will appear.
2. Click on the OK button.
Figure 4.106 — Configuration message
• To modify an OSPF Area
Note: When the 9500 MPR is used in MPR-e configuration with other equipment, the OSPF
interface parameters of the equipment must be the same as those of the related TMN
interface on the 9500 MPR.