Navigator area
266 MPR-e and MSS-1c User Manual 3DB19901EFAA Edition 01
Figure 4.86 — NE bridge mode selection
To create a Service VLAN:
• Push the button Add VLAN and fill the fields
• In column VLAN Id: Enter a valid VLAN Id (from 2 to 4080) and not used in another
VLAN or cross connection
• In column VLAN Name: Enter a name
• In columns User 1 to 4: Check the box if the port is implied in the VLAN. Both
enabled and disabled ports can be member of a VLAN. Note that radio port is
automatically included.
To remove a Service VLAN:
• Select its VLAN Id in the list
• Push the button Remove VLAN
If the configuration contains more than 20 VLANs, the keys <<, <, > and >> allows to
navigate between the different screens which display up to 20 VLANs each.
To Next Page
Loading...
