Navigator area
MPR-e and MSS-1c User Manual 3DB19901EFAA Edition 01 265
• In the column VLAN Name: Enter a name
• In the columns User 1 to 4: Check the box if the port is implied in the VLAN. Both
enabled and disabled ports can be member of a VLAN. Note that radio port is
automatically included.
• In the columns Untagged User 1 to 4: Check the box if you want the port removes
VLAN tag at egress.
To remove an existing virtual LAN:
• Select its VLAN Id in the list
• Push the button Remove VLAN
If the configuration contains more than 20 VLANs, the keys <<, <, > and >> allows to
navigate between the different screens which display up to 20 VLANs each.
4.9.1.4.9.7.2 — B) Configure the Q in Q mode and create S-VLANs
• Select the NE bridge mode in 802.1ad (Q in Q)
• Select a QoS mode: 802.1P, Diffserv or None
• Select a S-TPID in the proposed list or enter a custom one
• For each port, select the mode UNI or NNI
Note: If all ports are in UNI mode, the S-TPID configuration is not necessary.
Note: Only one S-VLAN is supported when the port is configured in UNI.
To Next Page
