Navigator area
MPR-e and MSS-1c User Manual 3DB19901EFAA Edition 01 291
• Rx Radio Link ID
• RTPC/ATPC
• RTPC Tx Power
• ATPC Min/Max Tx - RSL Threshold
• ATPC Driving Min/Max RSL
• MPR-A only: ATPC High Power Timeout enabled
• MPR-A only: ATPC High Power Mode command
• QoS - VLAN to queue mapping
• QoS - DiffServ to queue mapping
• QoS - 802.1p to queue mapping
• QoS - queue scheduling
• QoS - Ethertype to queue mapping
• QoS - Restore default
• QoS - Classification Configuration
• QoS - TMN Traffic parameters (4093)
• QoS - Queue Size
• PM - Counter Thresholds
• Configure Ethernet Compression
All other parameters, particularly troubleshooting commands, are not replicated. These
parameters and commands must be set properly on each MPT using the MCT.
4.9.1.4.15.1 — How to configure the synchronization:
1. Configure the main MPT according to the other procedures in the Configuration
section.
2. From the MCT connected to the main MPT, set up the synchronization:
• Click on the Align Spare MPT Configuration icon
To Next Page
