AT-x908 Gen2 Switch Installation Guide
35
Specifying Ports in the Command Line Interface
The individual ports on the switches in a stack are specified in the
command line interface with the PORT parameter. The format of the
parameter is shown in Figure 8.
Figure 8. PORT Parameter in the Command Line Interface
The three parts of the PORT parameter are described in Table 8.
Here is an example of the PORT parameter on a switch in a stack. It uses
the INTERFACE command to enter the Port Interface mode for ports 15
and 17 on the line card in slot 2:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.2.15,port1.2.17
For instructions on the command line interface and the PORT parameter,
refer to the Software Reference for AT-SBx908 Gen2 Switch, AlliedWare
Plus Operating System.
Table 8. PORT Parameter Format
Number Description
Stack ID Number Designates the switch’s ID number. The
number is 1. To determine the ID number
of a switch, examine its Switch ID LED.
Slot Number Designates the slot number with the line
card whose ports you want to configure.
For the AT-SBx908 Gen2 Switch this value
can be 1 to 8.
Port Number Designates a port number on an AT-
SBx908 Gen2 Ethernet line card.
port1
.n.n
Slot Number
Port Number
Stack ID Number
To Next Page
Loading...
Need help?
General
