AT-SBx908 Gen2 Switch Installation Guide
77
Installing the Power Cord Retaining Clips
The chassis comes with two power cord retaining clips in the accessory
kit. The clips are used to prevent the power cords from being accidentally
disconnected from the unit. To install a power cord retaining clip, press in
the sides and insert the ends into the holes above and below the AC
connector. Repeat to install the second power cord retaining clip. Refer to
Figure 46.
Figure 46. Installing the Power Cord Retaining Clips
After installing the retaining clips, go to Chapter 4, “Powering On the
Chassis” on page 79.
To Next Page
Loading...
Need help?
General
