Allied Telesis AT-SBx908 Gen2 - Figure 44: Aligning the Blank Power Supply Cover in the Slot; Figure 45: Lowering the Locking Handle on the Blank Power Supply Slot Cover

Chapter 3: Installing the Chassis
76
Figure 44. Aligning the Blank Power Supply Cover in the Slot
3. Lower the locking handle on the blank power supply slot cover to
secure the cover in the chassis. Refer to Figure 45.
Figure 45. Lowering the Locking Handle on the Blank Power Supply Slot
Cover
4. Go to “Installing the Power Cord Retaining Clips” on page 77.