Allied Telesis AT-SBx908 Gen2 - Page 9

AT-SBx908 Gen2 Switch Installation Guide
9
Figure 110: Placing the Ethernet Line Card in its Anti-static Bag.......................................................................................149
Figure 111: Loosening the Screws on the AT-FAN08 Module ...........................................................................................150
Figure 112: Disconnecting the AT-FAN08 Module from the Chassis .................................................................................151
Figure 113: Aligning the AT-FAN08 Module in the Chassis Slot ........................................................................................152
Figure 114: Seating the AT-FAN08 Module on the Connector in the Chassis ...................................................................152
Figure 115: Tightening the Two Captive Screws on the AT-FAN08 Module......................................................................153
Figure 116: Pin Layout (Front View) of the 1Gbps or 10Gbps Ports on the AT-XEM2-12XT Line Card............................166