Anritsu MT8820C - Page 158

158
3.7.4.2. Call Connection
No.
Call Connection Procedure
Remote Command
1.
Turn on UE power.
-
2.
Wait until position registration is completed.
Call Processing Status = Idle (Regist)
CALLSTAT? (= 2)
3.
Connect in Test Mode.
> Call Start
CALLSA
4.
Confirm call connected.
Call Processing Status = Connected
CALLSTAT? (= 6)
3.7.4.3. Measurement
No.
Call Connection Procedure
Remote Command
1.
Perform measurement.
> Single
> Continuous
SNGLS
SWP
2.
Wait until measurement completed.
Measurement Status = End
SWP? (= 0)
3.
Open throughput result screen.
Measurement tab > Numeric > Throughput
RLSTAREA
MEASTAB,FMEAS,NUM,TPUT
4.
Confirm uplink error free throughput.
UL_TPUT?
UL_TPUT? PCC
UL_TPUT? SCC1