Anritsu MT8820C - Inter-Frequency Handover

73
Inter-Frequency Handover 2.4.5.
For SCC–3, the following steps are added to the procedure in Chapter 2.3.6.
This chapter describes an example for FDD.
2.4.5.1. MT8821C
<Changing SCC–3 channel>
1. Execute DLCHAN_SCC3 400 to set Common Parameter – SCC-3 – DL Channel to 400.
2. Execute CALLSTATIC? to confirm the call processing stationary status is 6 (= Connected).
< Changing PCC channel, SCC–1 channel SCC–2 channel and SCC–3 channel at same time >
Cell
Channel (before)
Channel (after)
PCC
300
444
SCC–1
498
300
SCC–2
102
498
SCC–3
444
102
3. Execute DLCHAN 444, 300, 498, 102 to set Common Parameter – UL Channel and DL Channel to 18444
and 444, respectively. Moreover, set Common Parameter – SCC–1 DL Channel to 300 , SCC–2 DL Channel
to 498 and SCC–3 DL Channel to 102.
4. Execute CALLSTATIC? to confirm the call processing stationary status is 6 (= Connected).