Anritsu MT8820C - Bandwidth Handover

53
2.2.6.2. MT8821C
<Changing PCC channel>
1. Execute DLCHAN 302 to set Common Parameter - UL Channel and DL Channel to 18302 and 302,
respectively.
2. Execute CALLSTATIC? to confirm the call processing stationary status is 6 (= Connected).
<Changing SCC-1 channel>
1. Execute DLCHAN_SCC1 500 to set Common Parameter - SCC-1 - DL Channel to 500.
2. Execute CALLSTATIC? to confirm the call processing stationary status is 6 (= Connected).
<Changing PCC channel and SCC-1 channel at the same time>
Cell
Channel (before HO)
Channel (after HO)
PCC
300
498
SCC-1
498
300
1. Execute DLCHAN 498, 300 to set Common Parameter - UL Channel and DL Channel to 18498 and 498,
respectively. Moreover, set Call Processing Parameter - SCC-1 DL Channel to 300.
2. Execute CALLSTATIC? to confirm the call processing stationary status is 6 (= Connected).
<Swap PCC and SCC-1 simultaneously>
The SWAPHO command can completely swap PCC and SCC-1, including the channel bandwidth, DL/UL channel and
frequency setting, level setting and DL/UL RMC setting.
1. Execute TCC_SWAPHO SCC1 to set Call Processing Parameter - Carrier Aggregation - Target CC for Swap
HO to SCC1.
2. Execute SWAPHO to swap PCC and SCC-1 by handover procedure.
3. Execute CALLSTATIC? to confirm the call processing stationary status is 6 (= Connected).
Bandwidth Handover 2.2.7.
This chapter describes a setting example when Channel Bandwidth PCC and SCC are 20 MHz and 15 MHz,
respectively.
2.2.7.1. MT8820C
<Changing PCC Bandwidth>
1. [PCC] Execute BANDWIDTH 20MHZ to set Common Parameter - Channel Bandwidth to 20 MHz.
2. [SCC-1] Execute BANDWIDTH_PCC 20MHZ to set Call Processing Parameter - Carrier aggregation PCC -
Channel Bandwidth to 20 MHz.
3. [PCC] Execute CALLSTATIC? to confirm call processing status is 6 (= Connected)
<Changing SCC Bandwidth>
3. [PCC] Execute BANDWIDTH_SCC1 15MHZ to set Call Processing Parameter - Carrier aggregation SCC-1 -
Channel Bandwidth to 15 MHz.
4. [SCC-1] Execute BANDWIDTH 15MHZ to set Common Parameter - Channel Bandwidth to 15 MHz.
5. [PCC] Execute CALLSTATIC? to confirm call processing status is 6 (= Connected)
2.2.7.2. MT8821C
<Changing PCC Bandwidth>
1. Execute BANDWIDTH 20MHZ to set Common Parameter - Channel Bandwidth to 20 MHz.
2. Execute CALLSTATIC? to confirm the call processing stationary status is 6 (= Connected).
<Changing SCC Bandwidth>
3. Execute BANDWIDTH_SCC1 15MHZ to set Common Parameter - SCC-1 - Channel Bandwidth to 15 MHz.
4. Execute CALLSTATIC? to confirm the call processing stationary status is 6 (= Connected).