Anritsu MT8820C - Carrier Leakage (6.5.2.2); In-Band Emissions for Non Allocated RB - PUSCH (6.5.2.3)

94
Carrier leakage (6.5.2.2) 3.1.23.
This chapter describes a UL measurement example where (Modulation, RB) is (QPSK, PartialRB).
1. Execute MOD_AVG 20 to set the average count of Modulation Analysis to 20 times.
2. Execute TESTPRM TX_0DBM to set Test Parameter to TX1 - IBE/LEAK @ 0 dBm.
3. Execute ULRB_POS MIN to set UL RB Position to Min (#0).
4. Execute SWP to measure Modulation Analysis.
5. Execute CARRLEAK? MAX to read the Carrier Leakage measurement result.
6. Execute CARRLEAKPASS? to check that the Carrier Leakage Pass/Fail judgment is Pass.
7. Execute ULRB_POS MAX to set UL RB Position to Max (#max)
8. Execute steps 4 to 6.
9. Execute TESTPRM TX_M30DBM to set Test Parameter to TX1 - IBE/LEAK @ -30 dB.
10. Execute steps 3 to 8.
11. Execute TESTPRM TX_M40DBM_Q_P to set Test Parameter to TX1 - EVM/IBE/LEAK @ -40 dBm
(QPSK/PartialRB).
12. Execute steps 3 to 8.
NOTE 1: The UL RB Position of PartialRB allocation is Min (#0) or Max (#max).
In-band emissions for non allocated RB - PUSCH (6.5.2.3) 3.1.24.
This chapter describes a UL measurement example where (Modulation, RB) is (QPSK, PartialRB).
1. Execute MOD_AVG 20 to set the average count of Modulation Analysis to 20 times.
2. Execute TESTPRM TX_0DBM to set Test Parameter to TX1 - IBE/LEAK @ 0 dBm.
3. Execute ULRB_POS MIN to set UL RB Position to Min (#0).
4. Execute SWP to measure Modulation Analysis.
5. Execute INBANDE_GEN? MAX to read the In-band Emissions (General) measurement result.
6. Execute INBANDE_IMG? MAX to read the In-band Emissions (IQ Image) measurement result.
7. Execute INBANDE_LEAK? MAX to read the In-band Emissions (Carrier Leakage) measurement result.
8. Execute INBANDEPASS? to check that the In-band Emissions Pass/Fail judgment is Pass.
9. Execute ULRB_POS MAX to set UL RB Position to Max (#max).
10. Execute steps 4 to 8.
11. Execute TESTPRM TX_M30DBM to set Test Parameter to TX1 - IBE/LEAK @ -30 dBm.
12. Execute steps 3 to 10.
13. Execute TESTPRM TX_M40DBM_Q_P to set Test Parameter to TX1 - EVM/IBE/LEAK @ -40 dBm
(QPSK/PartialRB).
14. Execute steps 3 to 10.
NOTE 1: The UL RB Position for PartialRB allocation is Min (#0) or Max (#max).