Anritsu MT8820C - Bandwidth Handover

74
Bandwidth Handover 2.4.6.
For SCC–3, the following steps are added to the procedure in Chapter 2.3.7
This chapter describes an example to set parameters in the following table.
Parameter
Setting Value
Channel Bandwidth
PCC
20 MHz
SCC–1
15 MHz
SCC–2
10 MHz
SCC–3
10 MHz
2.4.6.1. MT8821C
<Changing SCC–3 Bandwidth>
3. Execute BANDWIDTH_SCC3 10MHZ to set Common Parameter – SCC-3 – Channel Bandwidth to 10 MHz.
4. Execute CALLSTATIC? to confirm the call processing stationary status is 6 (= Connected).