Anritsu MT8820C - Page 190

190
Figure 5.1.5.1-3 UL/DL RMC Settings at Common Parameter Setting Screen (MT8821C)
6. Press [Single] to confirm that the MT8821C downlink signal can be decoded at the UE by using the DL
Throughput and the Block Error Rate results of the Fundamental Measurement screen.
If there is an error, change the RMC settings or Level setting, and repeat steps 5 and 6.
Figure 5.1.5.1-4 Throughput Measurement Result for UE Category 3 at Fundamental Measurement Parameter
Screen (MT8820C)
Figure 5.1.5.1-5 Throughput Measurement Result for UE Category 3 at Fundamental Measurement Parameter
Screen (MT8821C)