Ontario Drive & Gear Limited www.odg.com
PH.(519)- 662-2840 FAX (519)- 662-2421
Argo Service Manual Transmission
TR-15
TR-30 TR-31
TR-32
23. Flip the Housing over to remove the outer Retaining Ring. Photo TR-32
24. Using the drift punch and hammer remove the inner Bearing in the same manner as
in step 20. Photo TR-33
25. Flip the transmission and remove the inner Retaining Ring. Photo TR-35
When removing this Bearing, take note of the number of Shims that were installed
behind it. This may vary from 1 to 2 shims. In any case, be sure to install the same
amount as was used previously. Photo TR-34
IMPORIMPOR
IMPORIMPOR
IMPOR
TT
TT
T
ANTANT
ANTANT
ANT
TR-33
TR-34 TR-35
To Next Page
Loading...
