Ontario Drive & Gear Limited www.odg.com
PH.(519)- 662-2840 FAX (519)- 662-2421
Transmission Argo Service Manual
TR-38
32. Place a Shim Washer on top of the previously installed Retaining Ring in the Hous-
ing’s Output Shaft side. Photo TR-130 & 131 (This may vary between 1 or 2
shims. Use the quantity previously used.)
34. Install (1) Bearing, shielded side down, into the Housing’s Shifter Assembly side.
Photo TR-134 & 135 (following Page)
31. Tap a burnishing tool through the shifter assembly's Oilite Bushing if the old bushing
has been replaced with a new one Photo TR-129
TR-127 TR-128
TR-129 TR-130
TR-131 TR-132
33. Install the Bearing to the top of the shim and seat with the arbor press. Photo TR-
132 & 133
To Next Page
Loading...
