Ontario Drive & Gear Limited www.odg.com
PH.(519)- 662-2840 FAX (519)- 662-2421
TR-24A
Transmission Argo Service Manual
TR-97
10. Lower the Reverse Idler Gear and install the second 107-11 Retaining Ring to the
machined groove at the top of the Reverse Idler Gear. Photo TR-98 & 99
TR-95 TR-96
11. Insert a tool, eg. an allen wrench, into the machined hole of the Reverse Shift Shaft
and turn the shaft until the keyways of both shaft and transmission boss are aligned.
Photo TR-100
iii Push the reverse shift shaft back through the housing ensuring that you don't damage
the O-ring as re-enters the housing.
8. Pull the Reverse Shift Shaft up until the lower retaining ring groove location is visible.
shaft is Photo TR-95
9. Install the 107-11 Retaining Ring onto the Reverse Shift Shaft. Photo TR-96 & 97
TR-98
To Next Page
Loading...
