Arkray AUTION MAX AX-4030 - Page 122

AX-4030
3-7
AUTION MAX AX-4030 OPERATING MANUAL
3 Press 3 to go to the [Measurement No. setup]
screen.
2 Set the measurement numbering method.
1 Select the options by pressing the hyphen key.
• To move the cursor up or down, press .
• For information about available options, see the
table on the previous page.
2 Press OK .
• A message window will open to ask if you want to
save your changes.
3 Save your changes.
1 Press OK to save your changes.
• The [Parameter settings] screen will appear again.
NOTE: Keep the power on while saving the
settings.
2 Press Go back twice on the [Parameter settings]
screen to return to the standby screen.
Parameter settings
(1000) 2006-01-09 11:00
1 Rack assignment for test strip
2 Results display format
3 Measurement No. setup
Measurement No. setup
(1300) 2006-01-09 11:00
Measurement start No.
[Continue from previous batch ]
Measurement No.
[Assign to samples ]
OK Cancel
Results display format
(1200) 2006-01-09 11:00
Sample
[Semiquantitative ]
Control
[Semiquantitative ]
OK Cancel
OK Cancel
Save setting changes?