The results obtained by measurement are stored in memory, and can be retrieved anytime as printed
or displayed reports or external output data. If the memory becomes full, the oldest data is replaced
with the latest one. Note that the deleted results can never be recovered. The maximum number of
results that can be stored in memory depend on the type of measurement as below.
Normal and STAT measurement Total of 2500 measurements
Control measurement Max. 200 measurements
Check measurement Max. 50 measurements
REFERENCE: You may not obtain printed reports or transmit data to an external device if
the built-in printer or external output capability is disabled. For more information, see “3.4.2
Enabling/Disabling the Built-in Printer” on page 3-18 and “3.4.3 Enabling/Disabling the External
Output” on page 3-20.
REFERENCE: Lists of errors, abnormal results, and parameter settings can also be printed out.
For instructions, see “3.5 [Print] Menu” on page 3-23.
3.3.1 Printing/Transmitting Results
The results stored in memory can be manually printed out or transferred to a connected external
device. You can specify what results you want by date, type of measurement, type of results, and
measurement number. Use the same procedure for printing and transmitting results (the following
procedure is explained with the screen images for printing as an example).
1 Access the setup screen.
1 On the standby screen, press Menu to go to the
[Main menu] screen.
2 Press 2 to go to the [Results] screen.
3 Press 1 to go to the [Print] screen.
Press 2 to go to the [Transmit] screen.
[Results] Menu3.3
To Next Page
Loading...
Need help?
General
