AX-4030
1-31
AUTION MAX AX-4030 OPERATING MANUAL
G
This section describes what you should do next after completing installation; it includes turning on
the power and setting up the printer and system clock. How to turn off the power is also explained
at the end of this section.
1.5.1 Turning On the Power for the First Time
Use the following procedure to turn on the instrument for the first time after installation. It will take
about 2 minutes for the instrument to complete warm-up.
1 Turn on the main power switch.
1 Press the I (on) side of the main power switch on
the rear panel.
2 Turn on the standby switch.
1 Press the standby switch on the left side of the front
panel.
• The standby switch will light green.
• The message “Please wait...” will appear for a
maximum of 20 seconds, followed by the product
name and program version for about 2 seconds.
NOTE: If the initial memory check detects a problem, the instrument will inform you of it by
indicating an appropriate warning (W), error (E), or trouble (T) code before displaying the
program version. For more information, see Chapter 5, “Troubleshooting”.
To Next Page
Loading...
Need help?
General
