• Reception of SNMPv3 notification messages (traps and informs)
• Configuration of initial users
• (Optional) Restriction of non-SNMPv3 messages to "read only"
2. Configure SNMPv3 users by entering the snmpv3 user command (see SNMPv3 users on page 147). Each
SNMPv3 user configuration is entered in the User Table.
3. Assign SNMPv3 users to security groups according to their level of access privilege by entering the snmpv3
group command (see
Assigning users to groups (CLI) on page 149).
4. Define the name of an SNMPv3 notification configuration by entering the snmpv3 notify command.
Syntax:
[no] snmpv3 notify <notify_name> tagvalue <tag_name> type {inform|trap}
Associates the name of an SNMPv3 notification configuration with a tag name used (internally) in SNMPv3
commands. To delete a notification-to-tag mapping, enter no snmpv3 notify notify_name .
notify <notify_name> Specifies the name of an SNMPv3 notification configuration.
tagvalue <tag_name> Specifies the name of a tag value used in other SNMPv3 commands, such as
snmpv3 targetaddress params taglist tag_name in Step 5.
type Specifies the notification type as inform or trap. By default, the notification
type is trap.
5. Configure the target address of the SNMPv3 management station to which SNMPv3 informs and traps are
sent by entering the snmpv3 targetaddress command.
Syntax:
[no] snmpv3 targetaddress {< ipv4-addr | ipv6-addr >} <name>
Configures the IPv4 or IPv6 address, name, and configuration filename of the SNMPv3 management station to
which notification messages are sent.
Chapter 8 Configuring for Network Management Applications 159
To Next Page