all
Configures the switch to send all debug message
types to configured debug destinations.(Default:
Disabled—No debug messages are sent.)
cdp
Sends CDP information to configured debug
destinations.
destination
logging—Disables or re-enables syslog logging on
one or more syslog servers configured with the
logging <syslog-ip-addr>
command.session—Assigns or re-assigns
destination status to the terminal device that was
most recently used to request debug output.buffer
—Enables syslog logging to send the debug
message types specified by the debug <debug-
type> command to a buffer in switch memory.
event
Configures the switch to send Event Log messages
to configured debug destinations.
NOTE: This value does not affect the
reception of event notification
messages in the Event Log on the
switch.
Event Log messages are automatically enabled to
be sent to debug destinations in these conditions:
• If no syslog server address is configured and you
enter the logging <syslog-ip-addr>
command to configure a destination address.
• If at least one syslog server address is configured
in the startup configuration, and the switch is
rebooted or reset.
Event log messages are the default type of debug
message sent to configured debug destinations.
ip [fib | packet]
Sends IP messages to configured destinations.
ip [fib [events]]
For the configured debug destinations:events—
Sends IP forwarding information base events.
ip [packet]
Enables the specified PIM message type.
Table Continued
Chapter 16 Troubleshooting 355
To Next Page
Loading...
