Aruba 2530 - Page 356

ipv6 [dhcpv6-client | nd | packet]
NOTE: See the "IPv6 Diagnostic and
Troubleshooting" in the IPv6
configuration guide for your switch for
more detailed IPv6 debug options.
When no debug options are included, displays
debug messages for all IPv6 debug options.
dhcpv6-client [events | packet]—Displays
DHCPv6 client event and packet data.nd—Displays
debug messages for IPv6 neighbor
discovery.packet—Displays IPv6 packet messages.
lldp
Enables all LLDP message types for the configured
destinations.
security [port-access | port-security |
radius-server | ssh | tacacs-server |
user-profile-mib]
port-access—Sends port-access debug
messages to the debug destination.radius-
server—Sends RADIUS debug messages to the
debug destination.ssh—Sends SSH debug
messages at the specified level to the debug
destination. The levels are fatal, error, info, verbose,
debug, debug2, and debug3.tacacs-server—
Sends TACACS debug messages to the debug
destination.user-profile-mib—Sends user
profile MIB debug messages to the debug
destination.
snmp <pdu>
Displays the SNMP debug messages.pdu—Displays
SNMP pdu debug messages.
Debug destinations
Use the debug destination command to enable (and disable)syslog messaging on a syslog server or to a CLI
session for specified types of debug and Event Log messages.
Syntax:
[no] debug destination {<logging | session | buffer>}
356 Aruba 2530 Management and Configuration Guide for
ArubaOS-Switch 16.05