SIP User's Manual 124 Document #: LTRT-65415
MediaPack Series
4. From the 'Profile Preference' drop-down list, select the priority of the IP Profile, where
'1' is the lowest priority and '20' is the highest. If both IP and Tel profiles apply to the
same call, the coders and other common parameters (noted by an asterisk) of the
preferred Profile are applied to that call. If the Preference of the Tel and IP Profiles is
identical, the Tel Profile parameters are applied.
Note: If the coder lists of both IP and Tel Profiles apply to the same call, only the
coders common to both are used. The order of the coders is determined by the
preference.
5. Configure the IP Profile's parameters according to your requirements.
6. From the 'Coder Group' drop-down list, select the coder group that you want to assign
to the IP Profile. You can select the device's default coders (see ''Configuring Coders''
on page 118), or on
e of the coder groups you defined in the 'Coder Group Settings'
page (see ''Configuring Coder Groups'' on page 119).
7. Rep
eat steps 2 through 6 for the next IP Profiles (optional).
8. Click the Submit button to save your changes.
9. To save the changes to flash memory, see ''Saving Configuration'' on page 169.
3.3.2.8 GW and IP to IP
The GW and IP to IP submenu configures the gateway as well as IP-to-IP parameters and
includes the following page items:
Trunk Group (see "Hunt Group" on page 124)
Manipul
ations (see "Manipulation" on page 129)
Routin
g (see "Routing" on page 137)
DTMF a
nd Supplementary (see ''DTMF and Supplementary'' on page 147)
Analog Gate
way (see "Analog Gateway" on page 149)
Advance
d Applications (see "Advanced Applications" on page 160)
3.3.2.8.1 Hunt Group
The Hunt Group submenu allows you to configure groups of channels called Hunt Groups.
This submenu includes the following page items:
Endpoint Phone Number (see "Configuring Endpoint Phone Numbers" on page 124)
Hunt G
roup Settings (see ''Configuring Hunt Group Settings'' on page 126)
3.3.2.8.1.1 Configuring Endpoint Phone Numbers
The 'Endpoint Phone Number Table' page allows you to activate the device's ports
(channels or endpoints), by defining telephone numbers for the endpoints and assigning
them to Hunt Groups and Tel Profiles.
Notes:
• Each endpoint must be assigned a unique phone number. In other
words, no two endpoints can have the same phone number.
• The number of endpoints depends on the MediaPack model (e.g., MP-
118 displays 8 endpoints).
• You can also configure the endpoint phone numbers using the ini file
table parameter TrunkGroup (see ''Number Manipulation and Routing
Parameters'' on page 474).
To Next Page
Loading...
Need help?
General
