SIP User's Manual 114 Document #: LTRT-65415
MediaPack Series
Table 3-18: Account Table Parameters Description
Parameter Description
Served Trunk Group
[Account_ServedTrunkGroup]
The Hunt Group ID for which you want to register and/or
authenticate to a destination IP Group (i.e., Serving IP Group).
For Tel-to-IP calls, the Served Hunt Group is the source Hunt
Group from where the call originated. For IP-to-Tel calls, the
Served Hunt Group is the 'Hunt Group ID' defined in the 'IP to Hunt
Group Routing Table' (see ''Configuring the IP to Hunt Group
Routing Table'' on page 142). Fo
r defining Hunt Groups, seeto
Configuring Endpoint Phone Numbers on page 124.
Serving IP Group
[Account_ServingIPGroup]
The destination IP Group ID (defined in ''Configuring IP Groups'' on
page 103) to
where the REGISTER requests (if enabled) are sent
or authentication is performed. The actual destination to where the
REGISTER requests are sent is the IP address defined for the
Proxy Set ID (see ''Configuring Proxy Sets Table'' on page 106)
asso
ciated with the IP Group. This occurs only in the following
conditions:
The parameter 'Registration Mode' is set to 'Per Account' in the
'Hunt Group Settings' table (see ''Configuring Hunt Group
Settings'' on page 126).
The parameter 'Register' in this table is set to 1.
In addition, for a SIP call that is identified by both the Served Hunt
Group and Serving IP Group, the username and password for
digest authentication defined in this table is used.
For Tel-to-IP calls, the Serving IP Group is the destination IP
Group defined in the 'Hunt Group Settings' table or 'Tel to IP
Routing' (see ''Configuring the Tel to IP Routing'' on page 138). For
IP-to-Tel calls, the Serving IP Group is th
e 'Source IP Group ID'
defined in the 'IP to Hunt Group Routing Table' (see ''Configuring
the IP to Hunt Group Routing Table'' on page 142).
Note: If no match is found in this table for incoming or outgoing
calls, the username and password defined in the 'Authentication'
table (see "Configuring Authentication" on page 153) or the global
para
meters (UserName and Password) defined on the 'Proxy &
Registration' page.
Username
[Account_Username]
Digest MD5 Authentication user name (up to 50 characters).
Password
[Account_Password]
Digest MD5 Authentication password (up to 50 characters).
Note: After you click the Apply button, this password is displayed
as an asterisk (*).
Host Name
[Account_HostName]
Defines the Address of Record (AOR) host name. It appears in
REGISTER From/To headers as ContactUser@HostName. For
successful registrations, this HostName is also included in the
INVITE request's From header URI. If not configured or if
registration fails, the 'SIP Group Name' parameter from the ‘IP
Group’ table is used instead.
This parameter can be up to 49 characters.
To Next Page
Loading...
Need help?
General
