Version 6.2 345 February 2011
SIP User's Manual 10. Configuration Parameters Reference
Parameter Description
Daylight Saving Time Parameters
Web: Day Light Saving Time
EMS: Mode
[DayLightSavingTimeEnable]
Determines whether to enable daylight saving time.
 [0] Disable (default)
 [1] Enable
Web: Start Time
EMS: Start
[DayLightSavingTimeStart]
Defines the date and time when daylight saving begins.
The format of the value is mo:dd:hh:mm (month, day, hour, and
minutes).
Web: End Time
EMS: End
[DayLightSavingTimeEnd]
Defines the date and time when daylight saving ends.
The format of the value is mo:dd:hh:mm (month, day, hour, and
minutes).
Web/EMS: Offset
[DayLightSavingTimeOffset]
Daylight saving time offset (in minutes).
The valid range is 0 to 120. The default is 60.
10.2 Web and Telnet Parameters
This subsection describes the device's Web and Telnet parameters.
10.2.1 General Parameters
The general Web and Telnet parameters are described in the table below.
Table 10-10: General Web and Telnet Parameters
Parameter Description
Web: Web and Telnet
Access List Table
EMS: Web Access
Addresses
[WebAccessList_x]
Defines up to ten IP addresses that are permitted to access the device's
Web interface and Telnet interfaces. Access from an undefined IP
address is denied. When no IP addresses are defined in this table, this
security feature is inactive (i.e., the device can be accessed from any IP
address).
The default value is 0.0.0.0 (i.e., the device can be accessed from any IP
address).
For example:
WebAccessList_0 = 10.13.2.66
WebAccessList_1 = 10.13.77.7
For defining the Web and Telnet Access list using the Web interface, see
''Configuring Web and Telnet Access List'' on page 70.
To Next Page
Loading...
Need help?
General
