SIP User's Manual 64 Document #: LTRT-65415
MediaPack Series
8. When the certificate has successfully loaded, save the configuration (see ''Saving
Configuration'' on page 169)
and restart the device; the Web interface uses the
provided certificate.
9. If the device was originally operating in HTTPS mode and you disabled it in Step 2,
then return it to HTTPS by setting the parameter 'Secured Web Connection (HTTPS)'
to 'HTTPS Only' (1) - see ''Configuring Web Security Settings'' on page 69.
Notes:
• The certificate replacement process can be repeated when necessary
(e.g., the new certificate expires).
• It is possible to use the IP address of the device (e.g., 10.3.3.1) instead
of a qualified DNS name in the Subject Name. This is not recommended
since the IP address is subject to changes and may not uniquely identify
the device.
• The server certificate can also be loaded via ini file using the parameter
HTTPSCertFileName.
¾ To apply the loaded certificate for IPSec negotiations:
1. Open the ‘IKE Table’ page (see Configuring the IP Security Proposal Table on page
94); the '
Loaded Certificates Files' group lists the newly uploaded certificates, as
shown below:
Figure 3-38: IKE Table Listing Loaded Certificate Files
2. Click the Apply button to load the certificates; future IKE negotiations are now
performed using the new certificates.