Version 6.2 181 February 2011
SIP User's Manual 3. Web-Based Management
¾ To activate the Message Log:
1. Activate and configure the device's Syslog client.
2. Open the 'Message Log' page (Status & Diagnostics tab > System Status menu >
Message Log); the 'Message Log' page is displayed and the log is activated.
Figure 3-112: Message Log Page
The displayed logged messages are color coded as follows:
• Yellow - fatal error message
• Blue - recoverable error message (i.e., non-fatal error)
• Black - notice message
3. To clear the page of Syslog messages, access the 'Message Log' page again (see
Step 2); the page is cleared and new messages begin appearing.
¾ To stop the Message Log:
Close the 'Message Log' page by accessing any another page in the Web interface.
To Next Page
Loading...
