AudioCodes MediaPack MP-124 User Manual

SIP User's Manual 364 Document #: LTRT-65415
MediaPack Series
10.4.7 OCSP Parameters
The Online Certificate Status Protocol (OCSP) parameters are described in the table
below.
Table 10-24: OCSP Parameters
Parameter Description
EMS: OCSP Enable
[OCSPEnable]
Enables or disables certificate checking using OCSP.
 [0] = Disable (default).
 [1] = Enable.
For a description of OCSP, refer to the Product Reference Manual.
EMS: OCSP Server IP
[OCSPServerIP]
Defines the IP address of the OCSP server.
The default IP address is 0.0.0.0.
[OCSPSecondaryServerIP]
Defines the IP address (in dotted-decimal notation) of the secondary
OCSP server (optional).
The default IP address is 0.0.0.0.
EMS: OCSP Server Port
[OCSPServerPort]
Defines the OCSP server's TCP port number.
The default port number is 2560.
EMS: OCSP Default
Response
[OCSPDefaultResponse]
Determines the default OCSP behavior when the server cannot be
contacted.
 [0] = Rejects peer certificate (default).
 [1] = Allows peer certificate.
10.5 RADIUS Parameters
The RADIUS parameters are described in the table below. For detailed information on the
supported RADIUS attributes, see ''Supported RADIUS Attributes'' on page 304.
Table 10
-25: RADIUS Parameters
Parameter Description
Web: Enable RADIUS Access
Control
[EnableRADIUS]
Determines whether the RADIUS application is enabled.
 [0] Disable = RADIUS application is disabled (default).
 [1] Enable = RADIUS application is enabled.
Note: For this parameter to take effect, a device reset is required.
Web: Accounting Server IP
Address
[RADIUSAccServerIP]
IP address of the RADIUS accounting server.
Web: Accounting Port
[RADIUSAccPort]
Port of the RADIUS accounting server.
The default value is 1646.
Web/EMS: RADIUS Accounting
Type
[RADIUSAccountingType]
Determines when the RADIUS accounting messages are sent to
the RADIUS accounting server.
 [0] At Call Release = Sent at call release only (default).
 [1] At Connect & Release = Sent at call connect and release.
 [2] At Setup & Release = Sent at call setup and release.

AudioCodes MediaPack MP-124 Specifications

General

Model	MediaPack MP-124
Category	Gateway
Protocols	SIP, H.323, MGCP
Voice Codecs	G.711, G.723.1, G.726, G.729A/B
Fax Support	T.38
Management	SNMP
Security	TLS/SRTP
Power Supply	100-240 VAC, 50/60 Hz
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Temperature	-25 to 70°C
Humidity	10% to 90%, non-condensing
Analog Ports	24 FXS