AudioCodes MediaPack MP-124 User Manual

SIP User's Manual 190 Document #: LTRT-65415
MediaPack Series
3.5.2.7 Viewing IP Connectivity
The 'IP Connectivity' page displays online, read-only network diagnostic connectivity
information on all destination IP addresses configured in the 'Tel to IP Routing' page (see
''Configuring Tel to IP Routing'' on page 138).
Notes:
• This information is available only if the parameter 'Enable Alt Routing Tel
to IP'/AltRoutingTel2IPMode (see ''Configuring General Routing
Parameters'' on page 137) is set to 1 (Enable) or 2 (Status Only).
• The information in columns 'Quality Status' and 'Quality Info' (per IP
address) is reset if two minutes elapse without a call to that destination.
¾ To view IP connectivity information:
1. In the 'Routing General Parameters' page, set the parameter 'Enable Alt Routing Tel
to IP' (or ini file parameter AltRoutingTel2IPEnable) to Enable [1] or Status Only [2].
2. Open the 'IP Connectivity' page (Status & Diagnostics tab > VoIP Status menu > IP
Connectivity).
Figure 3-121: IP Connectivity Page
Table 3-33: IP Connectivity Parameters
Column Name Description
IP Address
The IP address can be one of the following:
 IP address defined as the destination IP address in the 'Tel to IP Routing'.
 IP address resolved from the host name defined as the destination IP
address in the 'Tel to IP Routing'.
Host Name
Host name (or IP address) as defined in the 'Tel to IP Routing'.
Connectivity
Method
The method according to which the destination IP address is queried
periodically (ICMP ping or SIP OPTIONS request).
Connectivity
Status
The status of the IP address' connectivity according to the method in the
'Connectivity Method' field.
 OK = Remote side responds to periodic connectivity queries.
 Lost = Remote side didn't respond for a short period.
 Fail = Remote side doesn't respond.
 Init = Connectivity queries not started (e.g., IP address not resolved).
 Disable = The connectivity option is disabled, i.e., parameter 'Alt Routing Tel
to IP Mode' (AltRoutingTel2IPMode ini) is set to 'None' or 'QoS'.

AudioCodes MediaPack MP-124 Specifications

General

Model	MediaPack MP-124
Category	Gateway
Protocols	SIP, H.323, MGCP
Voice Codecs	G.711, G.723.1, G.726, G.729A/B
Fax Support	T.38
Management	SNMP
Security	TLS/SRTP
Power Supply	100-240 VAC, 50/60 Hz
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Temperature	-25 to 70°C
Humidity	10% to 90%, non-condensing
Analog Ports	24 FXS