EasyManua.ls Logo

AudioCodes MediaPack MP-124

AudioCodes MediaPack MP-124
504 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SIP User's Manual 464 Document #: LTRT-65415
MediaPack Series
Parameter Description
FXSPort_Last = end range of FXS ports.
SourcePrefix = prefix of the calling number.
DestinationPrefix = prefix of the called number.
PriorityIndex = index for Distinctive Ringing and Call
Waiting tones (default is 0):
9 Ringing tone index = index in the CPT file for playing
the ring tone.
9 Call Waiting tone index = priority index +
FirstCallWaitingToneID(*). For example, if you want to
select the Call Waiting tone defined in the CPT file at
Index #9, then you can enter 1 as the priority index
and the value 8 for FirstCallWaitingToneID. The
summation of these values equals 9, i.e., index #9.
For example, the configuration below plays the tone Index #3
to FXS ports 1 and 2 if the source number prefix of the
received call is 20.
ToneIndex 1 = 1, 2, 20*, , 3;
Notes:
You can define up to 50 indices.
This parameter is applicable only to FXS interfaces.
Typically, the Ringing and/or Call Waiting tone played is
indicated in the SIP Alert-Info header field of the received
INVITE message. If this header is not present, then the
tone played is according to the settings of this table.
For depicting a range of FXS ports, use the syntax x-y
(e.g., "1-4" for ports 1 through 4).
You can configure multiple entries with different source
and/or destination prefixes and tones for the same FXS
port.
10.12.7.2 Tone Detection Parameters
The signal tone detection parameters are described in the table below.
Table 10-54: Tone Detection Parameters
Parameter Description
EMS: DTMF Enable
[DTMFDetectorEnable]
Enables or disables the detection of DTMF signaling.
[0] = Disable
[1] = Enable (default)
EMS: MF R1 Enable
[MFR1DetectorEnable]
Enables or disables the detection of MF-R1 signaling.
[0] = Disable (default)
[1] = Enable
EMS: User Defined Tone Enable
[UserDefinedToneDetectorEnable]
Enables or disables the detection of User Defined Tones
signaling, applicable for Special Information Tone (SIT)
detection.
[0] = Disable (default)
[1] = Enable

Table of Contents

Other manuals for AudioCodes MediaPack MP-124

Related product manuals