SIP User's Manual 292 Document #: LTRT-65415
MediaPack Series
8.3.3.4.1 Gateway with SAS Outbound Mode
The procedure below describes how to configure the Gateway application with SAS
outbound mode.
¾ To configure Gateway application with SAS outbound mode:
1. Define the proxy server address for the Gateway application:
a. Open the 'Proxy & Registration' page (Configuration tab > VoIP menu > SIP
Definitions submenu > Proxy & Registration).
b. From the 'Use Default Proxy' drop-down list, select 'Yes'.
Figure 8-40: Enabling Proxy Server for Gateway Application
c. Click Submit.
d. Open the 'Proxy Sets Table' page (Configuration tab > VoIP menu > Control
Network submenu > Proxy Sets Table).
e. From the 'Proxy Set ID' drop-down list, select '0'.
f. In the first 'Proxy Address' field, enter the IP address and port of the device (in
the format x.x.x.x:port). This is the port as defined in the 'SAS Local
UDP/TCP/TLS Port' field (see ''Configuring Common SAS Parameters'' on page
288).
Figure 8-41: Defining Proxy Server for Gateway Application
g. Click Submit.
To Next Page
Loading...
